Plexiglas Cement (the watery thin solvent type) w/ needle-tipped squeeze bottle applicator

1/4" thick clear acrylic (I used Plexiglas), the following count and sizes:
(2) pieces 14.5" by 16.5" (sides)
(2) pieces 5" by 14.25" (ends)
1 piece 5" by 16.5" (bottom)
1 piece scrap (just needs to be a few inches on each side)

1/8" thick acrylic, "pebble surface both sides" (similar to what you might find a shower door made out of (although possibly a bit thinner than normally used for that purpose), the texture of it is to help keep the wet prints from sticking to the partitions):
(3) pieces 14.25" by 16.125" (partitions)

Wet-or-dry sandpaper, 2 sheets each of 200-300 and 400 grit

Masking tape

Patience